You are here: Home » Blog » How to Operate the Guillotine Shearing Machine Correctly

How to Operate the Guillotine Shearing Machine Correctly

Views:92     Author:Site Editor     Publish Time: 2020-08-24      Origin:Site

Start the shearing machine for a few cycles of idling, to ensure that under normal conditions, test cuts of different thicknesses, from thin to thick. Ensure that the user is familiar with the hydraulic guillotine shear performance. Different blade gaps must be adjusted for different plate thicknesses during trial cutting. If the corresponding blade gap is not adjusted, the blade durability will be affected.

 

The hydraulic shearing machine turns on the pressure gauge switch during the cutting process and observes the pressure value of the oil circuit. The pressure should be less than 20MPa when cutting a 12mm sheet plate. This remote pressure regulating valve No.9, the pressure is set to 20-22MPa at the factory. The user should abide by this regulation, and shall not increase the pressure on the material surface to cut over the prescribed material and cause damage to the machine. Sound balance during operation. If there is noise in the shears, stop and check.

 

hydraulic guillotine shear


When the guillotine shearing machine is operating, the oil tank temperature is increased less than 60 degrees, and the machine is shut down for rest.

 

Use and maintenance of hydraulic guillotine shears:

1. Operate strictly in accordance with operating procedures.

2. Add lubricating oil according to the requirements of the lubrication chart every time before starting the machine. The oil should be clean and free of precipitation.

3. The guillotine shearing machine tool must be kept clean frequently, and the unpainted parts should be coated with anti-rust grease.

4. The lubrication oil in the motor bearing should be replaced and refilled regularly, and the electrical part should be regularly checked for normal, safe, and reliable operation.

5. Regularly check whether the V-belt, handles, knobs, buttons are damaged, and those with serious wear should be replaced in time, and the spare parts should be reported for the supplement.

6. Regularly check and repair switches, insurances, and handles to ensure reliable operation.

7. Lubricate and scrub the machine tool 10 minutes before getting off work every day.

8. It is strictly forbidden for non-designated personnel to operate the equipment, and it must be stopped by people off the machine.

 

Zhongrui is hydraulic shearing machine manufacturers, providing high quality guillotine shearing machine and professional hydraulic guillotine shear information. If you have any needs, please contact us!


Product Category

Get In Touch

Email: info@raymaxlaser.com
Tel: 0086-555-6767999
Cell: 0086-17755591284
         0086-18855564958

Contact Us

ABOUT ANHUI ZHONGRUI

We are dedicated to the R&D and manufacturing of medium or high -level processing equipments and press lines for punching, shearing, press brake and laser cutting of metal plates.
0086-555 6767999
  0086-17755591284
  0086-18855564958
 info@raymaxlaser.com

WHERE TO FIND US

SITE NAVIGATION

FOLLOW US

KEEP IN TOUCH
Copyright © Anhui Zhongrui Machine Manufacturing Co., Ltd. All Rights Reserved.